Green Tea Foam

0
Average: 0 (0 votes)
(0 votes)
Green Tea Foam
share Share
print
bookmark_border Copy URL
Health Score:
87 / 100
Difficulty:
moderate
Difficulty
Preparation:
15 min.
Preparation
ready in 1 hr 45 min.
Ready in
Calories:
68
calories
Calories

Nutritional values

1 serving contains
(Percentage of daily recommendation)
Calorie68 cal.(3 %)
Protein5 g(5 %)
Fat2 g(2 %)
Carbohydrates5 g(3 %)
Sugar added0 g(0 %)
Roughage2.4 g(8 %)
Vitamin A0 mg(0 %)
Vitamin D0.1 μg(1 %)
Vitamin E0.4 mg(3 %)
Vitamin K5.7 μg(10 %)
Vitamin B₁0 mg(0 %)
Vitamin B₂0.1 mg(9 %)
Niacin0.7 mg(6 %)
Vitamin B₆0.1 mg(7 %)
Folate21 μg(7 %)
Pantothenic acid0.4 mg(7 %)
Biotin3.6 μg(8 %)
Vitamin B₁₂0.3 μg(10 %)
Vitamin C14 mg(15 %)
Potassium192 mg(5 %)
Calcium99 mg(10 %)
Magnesium23 mg(8 %)
Iron0.5 mg(3 %)
Iodine9 μg(5 %)
Zinc0.4 mg(5 %)
Saturated fatty acids1.6 g
Uric acid9 mg
Cholesterol6 mg
Complete sugar5 g

Ingredients

for
2
Ingredients
cup milk (hot)
3 Green tea
1 Gelatin sheet
1 cup Raspberries
How healthy are the main ingredients?
RaspberryGreen tea

Preparation steps

1.
Pour the hot milk into a pot and let it steep with green tea for 30 minutes. Add the gelatin and let it bloom for 5 to 10 minutes. Once bloomed, heat the pot over medium heat while stirring until the gelatin dissolves.
2.
Remove the dispenser from the box including the charger holder and two dispenser tips. Unscrew the top off the dispenser, then screw on the tip of your choice (straight or tulip) while holding in place the valve stem under the cap. Be sure to screw the tip on tightly. Make sure that the gasket (also called the O-ring) is firmly in place on the underside of the head.
3.
Pour the green tea milk liquid into the siphon of the dispenser. Do not exceed recommended amount. Screw the top evenly and firmly onto the bottle. Do not cross-thread. Place a n2o cartridge in the holder with the small end visible. Twist charger holder onto head until gas is released. A slight hissing sound will be heard. For a pint dispenser, use only one charger per filling. For a quart dispenser, use two chargers per filling. Put the siphon in the fridge to cool it for 1 hour to allow the gelatin to set.
4.
Shake the dispenser 3-6 times. Turn the dispenser upside down. This is important, otherwise gas will escape and a proportionate amount of foam will not be released. Place the berries in the bottom of a bowl and dispense foam on each as needed by pressing on the lever. If the mixture is too runny, shake the dispenser a few more times and try again. If desired, the holder can be removed along with the used charger and the small cap put in its place.
5.
When the canister is empty, simply discharge any remaining pressure in a sink or wastepaper basket and unscrew the top. The small brush that is included is useful for cleaning the tips. Do not put dispensers in a commercial dishwasher.

Fall Favorites

Get Fit!

Simple, But Good

Weeknight Dinners

Popular Cookbooks