Fish in a Potato Cream with Beetroot Foam

0
Average: 0 (0 votes)
(0 votes)
Fish in a Potato Cream with Beetroot Foam
share Share
print
bookmark_border Copy URL
Difficulty:
moderate
Difficulty
Preparation:
50 min.
Preparation
ready in 1 hr 20 min.
Ready in

Ingredients

for
4
Ingredients
¾ cup butter (softened)
79 ozs russet potato (or yukon gold potatoes)
1 cup cream cheese (softened)
1 cup heavy cream
2 cups milk
1 Tbsp salt
2 tsps Black pepper
4 Arctic char fillets (skin on)
2 yellow carrots (halved, cleaned well and skins left on)
¾ cup Beet juice
1 tsp Soy lecithin
How healthy are the main ingredients?
cream cheesesaltcarrot

Preparation steps

1.
Peel and cut the potatoes into chunks. Bring a large pot of water to a simmer and add the potatoes. Bring to a boil and cook until fork tender, 20 to 25 minutes.
2.
Drain the potatoes in a large colander. Place them back into the dry pot and put the pot on the stove. Mash the potatoes over low heat, allowing all the steam to escape before adding in all the other ingredients. Place in a food processor and add 1 1/2 sticks butter, the cream cheese, heavy cream, milk, kosher salt and pepper to taste. Pulse until the potato cream is thin and mixed well. Set aside.
3.
Preheat the oven to 350 degrees F. Place fish and 4 carrot halves in an even layer in a baking dish. Season fish and carrots with salt and black pepper, cover baking dish with parchment paper-lined aluminum foil, and transfer to oven. Cook until fish and carrots until cooked through, about 10-15 minutes depending on the thickness of your fillets.
4.
Remove the dispenser from the box including the charger holder and two dispenser tips. Unscrew the top off the dispenser, then screw on the tip of your choice (straight or tulip) while holding in place the valve stem under the cap. Be sure to screw the tip on tightly. Make sure that the gasket (also called the O-ring) is firmly in place on the underside of the head.
5.
Combine the beetroot juice and soy lecithin together in a bowl and mix well. Pour the foam liquid mixture it into the siphon of the dispenser. Do not exceed recommended amount. Screw the top evenly and firmly onto the bottle. Do not cross-thread. Place a n2o cartridge in the holder with the small end visible. Twist charger holder onto head until gas is released. A slight hissing sound will be heard. For a pint dispenser, use only one charger per filling. For a quart dispenser, use two chargers per filling. Put the siphon in the fridge to cool it for 30 minutes.
6.
Shake the dispenser 3-6 times. Turn the dispenser upside down. This is important, otherwise gas will escape and a proportionate amount of foam will not be released. To plate this dish, spoon the potato foam in a shallow bowl and top with one piece of char (skin side up). Garnish the fish with one piece of carrot and if desired, a few fresh green peas. Dispense beetroot foam onto fish as needed by pressing on the lever. If the mixture is too runny, shake the dispenser a few more times and try again. If desired, the holder can be removed along with the used charger and the small cap put in its place.
7.
When the canister is empty, simply discharge any remaining pressure in a sink or wastepaper basket and unscrew the top. The small brush that is included is useful for cleaning the tips. Do not put dispensers in a commercial dishwasher.

Fall Favorites

Get Fit!

Simple, But Good

Weeknight Dinners